jaeab.blogg.se

If you cannot connect to your Wi-Fi network, make sure that you are using the correct Wi-Fi name ( SSID) and password. Your Wi-Fi is on, and you should be able to connect. Wait 2-3 minutes for the power, internet and Wi-Fi LEDs to turn to solid blueĭevice is connected to the network and online (talking to ACS).Wait 2-3 minutes for the power, internet and Wi-Fi LEDs to turn to solid blueĭevice is connected to the network and online Powering up or trying to connect to the network Wait 2-3 minutes for the power, internet and Wi-Fi LEDs to turn to solid blue.Plug the power cord back in to the device.Make sure that the ethernet cable is securely connected. No optical connection or Fiber Jack is ranged but not authenticated.Ī device is connected but not passing traffic. Unplug your Fiber Jack from its power source (which depending on your setup, could be a power outlet, ethernet cord plugged into a router, or an ethernet cord plugged into a port in a wall plate.).Wait three minutes for the Fiber Jack to begin working again. Then reconnect your Fiber Jack to the power source.Wait 30 seconds, and plug the ethernet cord back in.Then, unplug your Fiber Jack's ethernet cable from the device it's connected to.Unplug your Fiber Jack from its power source.Remove the bottom cover and make sure that the power button is depressed.The optical connection port, power adapter port, PoE, and reset pin are on the side of the FJ, from left to right, respectively.Ĭlick the GFLT100, GFLT110, or GFLT300 headline directly above to view images of these Fiber Jack models, and use the following information to check the LED light status.įiber Jack (GFLT100, GFLT110, GFLT300, GFLT132, GOGP220C, GOGP222C, and GOXP330C) product info can be found here.The LED indicator is on the front of the device above the Google Fiber label.This model is capable of Power over ethernet (POE). It is currently the standard for new installations for Google Fiber. The optical connection port is on the bottom of the device.The ethernet port, reset button, and power adapter port are on the top of the FJ, from left to right, respectively.The LED indicator is on the front of the device in the upper-right corner.It has been discontinued but some customers may still have FJ 1.0 if they have not upgraded to FJ 2.0.